Language
language
中国
韩国
韩国
韩国
韩国
韩国
NEWS CENTER
DWSK Sprocket
Position:
Home
/
/
/
Maintenance of Simplex sprocket

Maintenance of Simplex sprocket

(Summary description)This article introduces the maintenance methods of the Simplex sprocket

Maintenance of Simplex sprocket

(Summary description)This article introduces the maintenance methods of the Simplex sprocket

Information

1. Simplex sprocket should be tight enough to increase power consumption and bearing wear easily.Too loose sprockets can easily jump and unchain.Sprockets are lifted or pressed from the middle of the Simplex sprocket.

2. Simplex sprocket should be installed on the shaft without swing or skewing.In the same drive assembly, the end faces of two sprockets should be in the same plane, and the sprocket center distance below 0.5 m can be deviated by 1 mm;Simplex sprocket centers can be deviated by 2 mm over 0.5 m.However, the side phenomenon of friction sprocket teeth can not be avoided. If the two wheels offset too much, it is easy to cause chain breakdown and accelerated wear.Care must be taken to check and adjust the offset when replacing the Simplex sprocket.

3. After severe wear of Simplex sprocket, new sprockets and sprockets should be replaced at the same time to ensure good engagement.New sprockets or sprockets cannot be replaced alone.Otherwise, poor engagement will result in accelerating wear on new sprockets or sprockets.Simplex sprocket teeth should be turned over in time after wear to a certain extent (refers to sprockets with adjustable surfaces) to extend the use time.

4. Simplex sprocket is too long or elongated after use, so it is difficult to adjust. It can be seen that the chain links are removed, but they must be even.The chain link should pass through the back of the sprocket with the locking tab inserted outside and the opening of the locking tab pointing in the opposite direction of rotation.

5. Simplex sprocket should be filled with lubricant in time.Lubricant must enter the mating clearance between the roller and the inner sleeve to improve working conditions and reduce wear.

6. The old Simplex sprocket can not be mixed with some new sprockets. Otherwise, it is easy to impact the transmission and break the Simplex sprocket.

7. When the machine is stored for a long time, Simplex sprocket should be removed and cleaned with kerosene or diesel oil, then coated with oil or butter and stored in a dry place.

 

Keyword:

Scan the QR code to read on your phone

Previous: None
Next: None
Previous: None
Next: None

DWSK SPROCKET

ADD: Shimenqiao Industrial Zone, Renqiu City, Hebei Province, China
TEL: 
0086-317-2805558
FAX: 0086-317-2805556
QQ: 1148504595
E-MAIL:
dwsk@vip.126.com

Alibaba: DongWang Sprocket

COPYRIGHT © RenQiu Dong Wang Machinery Parts Co., Ltd.         冀ICP备19028325号-1       Power by 300.cn