Customized sprocket B type single products Introduce some knowledge to pay attention to when replacing the sprocket
After the sprocket is seriously worn, it should be replaced with a new sprocket and a new sprocket at the same time to ensure good meshing. You can't just replace a new sprocket or a new sprocket alone.
Be careful to check and adjust the offset when replacing sprockets. Let's follow the customized sprocket B type single products editor for a brief understanding!
After the sprocket is seriously worn, it should be replaced with a new sprocket and a new sprocket at the same time to ensure good meshing. You can't just replace a new sprocket or a new sprocket alone. Otherwise, it will cause poor meshing and accelerate the wear of the new sprocket or the new sprocket. After the sprocket tooth surface is worn to a certain extent, it should be turned over and used in time (referring to the sprocket used on the adjustable surface) to prolong the use time. If the new sprocket is too long or stretched after use, it is difficult to adjust. You can remove the chain link according to the situation, but it needs to be an even number. The links should pass through the back of the sprocket with the cleats inserted outside and the openings of the cleats should be facing the opposite direction of rotation. The sprocket should be filled with lubricating oil in time during work. Lubricating oil needs to enter the fitting clearance of the roller and the inner sleeve to improve working conditions and reduce wear. The old sprocket cannot be mixed with some new sprockets, otherwise it will easily cause shock during transmission and break the sprocket. When the machine is stored for a long time, the sprocket should be removed and cleaned with kerosene or diesel oil, then coated with oil or butter and stored in a dry place. The commonly used sprocket structure, small diameter sprockets are generally made of integral type, and medium diameter sprockets are mostly made of spoke type. Combined type, the ring gear and wheel core can be made of different materials.
The above is the small series of customized sprocket B type single products: a brief introduction to some small knowledge that needs to be paid attention to when replacing the sprocket.